Zektor DVS5.1 Owner's Manual download pdf (Page 14)

Setting Power On Defaults

The DVS5.1 power on default mode

When toggling between Standby mode and PowerOn, the DVS5.1 will remember all it’s current set-

tings. After completely powering down the DVS5.1 (by unplugging the AC wall adapter), upon re-

storing power (by plugging the AC wall adapter back in), it will power up in a user settable default

mode. This is useful in situations where the DVS5.1 is externally switched by a power strip.

The factory default settings for initial power on are:

• Initially power up in Standby mode.

• Input 1 will be selected when POWERTOGGLE button pressed.

• Auto-dimming mode selected.

Changing the DVS5.1 power on defaults

Teaching the DVS5.1 new power on default settings consists of placing the DVS5.1 in the preferred

initial power on mode, and pressing and releasing the SETUP button on the back panel of the

DVS5.1.

STEP 1 1 Select an initial power on input.

Using the SELECTIN1 - SELECTIN5 keys, or the SELECT+ or SELECT-

keys, choose the desired power on default input.

STEP 2 2 Select the initial Bright / Dim / Auto-dimming mode.

Using the SETDIMMODE key, choose the desired power on default

Bright / Dim / Auto-dimming mode.

STEP 3 3 Select the initial power mode, Standby or Powered on.

Using the POWERTOGGLE, POWERON or POWEROFF keys, choose

the initial power on mode.

STEP 4 4 Press and release the SETUP button located on the back panel of

the DVS5.1. The power indicator light on the DVS5.1 will blink once

to indicate the new power on settings have been saved.

or The previous picture shows the default power up mode, as being

set to the standby mode. It may also be set to the power on mode,

by pressing and releasing the setup key while power is on, as

shown here.

4 5 Audio321

ZEKTOR

4 5 Audio321

ZEKTOR

4 5 Audio321

ZEKTOR

4 5 Audio321

ZEKTOR

4 5 Audio321

ZEKTOR

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Zektor DVS5.1 Owner's Manual Page 14