Zektor DVS5.1 User Manual download pdf (Page 7)

Auto Status Control

X0<CR> Turn off auto-status transmissions

X1<CR> Turn on auto-status transmissions

X?<CR> Request current auto status setting

The MAS3 can be set to send a status message when any of the following occur (outside of an RS-232 command):

• A new channel is selected. Sends a Channel Status string

• The power state changes. Sends a Power Status string

• The state of the lamp intensity changes. Sends a Lamp Status string

The responses are identical to the responses you receive when you request the information using the “?” parameter

for each of the above commands.

When ‘X0<CR>’ is issued, these above actions will not automatically be sent, but will be buffered.

When ‘X1<CR>’ is issued, any pending status messages will be sent, and from then on, any of the above actions

will cause a status message to be immediately sent.

Status changes made through the RS-232 will not cause the above status strings to be automatically sent. For in-

stance, a button press will send a Channel Status string, an IR remote Channel change will send a Channel Status

string, however the command ‘C+<CR>’ will only be followed by the ‘+<CR><LF>’ acknowledgement string.

See the section on MAS3 status strings for the syntax of the status strings.

Query Command Status

Q<CR> Request information on MAS3 command states

If the command ‘X0<CR>’ has been issued then command statuses will not be immediately sent but instead buff-

ered. This command returns a bitmap that indicates what statuses are buffered and need to be read.

See the section on MAS3 status strings for the syntax of the returned string.

Save Current State As Power On Default

S<CR> Save MAS3’s current state as the power on default

Request Version

V<CR> Request the MAS3’s version

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Zektor DVS5.1 User Manual Page 7